35
Chapter 2 Setup
Using 40 mm Wide Roll Paper
Attach both the 40-mm and 58-mm width roll paper guides.
Follow the procedure below to attach the 40-mm width roll paper guide.
1
Lay the printer on its side.
2
Open the roll paper cover.
"Opening/Closing the Roll Paper Cover" on page 63
3
Tilt the guide and insert its protrusion into the groove inside the printer, and then fit
it into place.
4
By using TM-L100 Utility, change the paper width setting of the printer to 40 mm.
For more details, see
"Software Settings" on page 77
.
How to remove the 40-mm width roll paper guide
Remove the roll paper guide by pulling its tab up and toward you.
