Rev.B
General Specifications Appendix A-5
TM-L90 Service Manual
Confidential
Paper Roll Supply Device
Note:
Once the printer is used, do not change the paper width from narrow to wide. Otherwise, printing
problems and paper-cutting problems may occur. There are two reasons for this restriction, as the follows.
❏
The area on the print head where the paper does not pass can be worn out, since the platen directly
contacts the head.
❏
The wear rate on the cutter blades differs between the areas where the paper passes and does not,
which can result in paper-cutting problems.
However, if the printer is new, you can change the paper width from narrow to wide.
Supply method:
Drop-in paper roll
Near-end detector
Detection method:
Micro switch
Paper roll core
diameter:
Inside: 25.4 mm {1"}, Outside: 31.4 mm {1.24"}
Near-end adjustment:
Adjusting screw
Fixed position #1 (diameter: approximately 36 mm {1.42"}),
#2 (diameter: approximately 41 mm {1.61"})
Paper width selection:
80 mm {3.15"} (default setting)
38 mm or 60 mm {1.5 or 2.36"} paper width can be selected
using the label paper spacer packed in the box.
(By adjusting the label paper spacer, it is also possible to
set optional positions in the range of 38 mm to 70 mm {1.5
to 2.76"}.
When you attach the label paper spacer, you must also
specify the paper width setting in the NV memory to
match the print areas.
