TM200 Service Manual
- 3 -
Autocutter
Partial cut:
Cutting with one point center uncut
(selectable by ESC I or
GS V
)
Full cut:
Cutting without uncut (selectable by ESC i
)
Note:
To prevent dot displacement, after cutting, paper must be fed approximately 1 mm (14/360 or
0.04 inch) or more before printing.
Paper Specifications
Paper type:
Specified thermal roll paper
Form:
Paper roll
Paper width:
79.5 ±0.5 mm (3.13" ± 0.02")
Paper roll size:
Roll diameter:
Maximum 83 mm (3.27")
Take-up paper roll width:
80 + 0.5 / -1.0 mm
Paper roll diameter:
Inside: 12 mm (0.47")
Outside: 18 mm (0.71")
CAUTION:
Paper must not be pasted to the paper roll.
Printable Area
Paper roll
The printable area of a paper with width of 79.5 ± 0.5 mm
(3.13" ± 0.02") is 72.2 ± 0.2 mm (2.84" ± 0.008") (576 dots)
Internal Buffer
Receive buffer selectable as 2KB or 96KB using the DIP switch.
Non-volatile bit image buffer: 128KB
Electrical Specifications
Supply voltage:
+24 VDC
±
7%
Current consumption (at 24V, normal
temperature)
High-speed mode:
Mean: Approximately 1.8A
(Font A alphanumeric character printing for all columns)
Peak: Approximately 7.8A
Standby:
Mean: Approximately 0.2A
Note :
Maximum 1A for drawer kick-out driving.
