Setting Up the Printer
1–15
Notes:
Changes in DIP switch settings (excluding switches 2-7 and 2-8)
are recognized only when the printer power is turned on or when the
printer is reset by using the interface. If the DIP switch setting is
changed after the printer power is turned on, the change does not
take effect until the printer is turned on again or is reset.
If DIP switch 2-7 or 2-8 is turned on while the printer is turned on,
the printer may be reset, depending on the signal state.
DIP switches should not be changed while the printer power is on.
1-6
Parity selection
Even
Odd
1-7, 1-8
Transmission speed (see table below)
Transmission Speed
Transmission Speed (BPS)-bits per second
1-7
1-8
2400
ON
ON
4800
OFF
ON
9600
ON
OFF
19200
OFF
OFF
DIP Switch Set 2
Switch
Function
ON
OFF
2-1
Handshaking (BUSY condition)
Receive buffer
full
Off line or receive
buffer full
2-2
Not defined
—
—
2-3
Select number of characters per
line (CPL) 7
×
9 font/9
×
9 font
42CPL/35CPL
40CPL/33CPL
2-4, 2-5
Not defined
—
—
2-6
Internal use
—
Fixed to Off
2-7
I/F pin 6 reset signal
Enabled
Disabled
2-8
I/F pin 25 reset signal
Enabled
Disabled
DIP Switch Set 1
Switch
Function
ON
OFF
Summary of Contents for U325 - TM B/W Dot-matrix Printer
