2
Precautions
CAUTIONS:
Disconnect the power supply from the printer before you remove the
UB-S01; otherwise you may damage the UB-S01 and the printer. You
must disconnect the power supply because the electrical current is
flowing in some parts of the printer circuit even when the power switch
is turned off.
Wear a grounded wrist strap when handling the UB-S01 to prevent
damage from static electricity.
To avoid contamination, do not touch the board connector.
Unpacking
Make sure you have these items:
❏
UB-S01
❏
This manual
Procedure
1.
Remove the two screws that securing the UB-BOARD; then pull the UB-
BOARD to remove it.
CAUTION:
Put the UB-BOARD into an anti-static bag for storage to prevent
damage from static electricity.
2.
Hold the UB-S01 as shown in the illustration below. Push the UB-S01 in
gently until you feel the connector fit into place.
3.
Secure the UB-S01 with the two screws.
4.
Change the printer DIP switches to match the printer to the new interface.
See the printer documentation for information about these settings.
Make sure you set the printer DIP switches. Otherwise the printer may
not work correctly.
Connector of the UB-S01
Connector of the TM printer
