9. Lower the ADF input tray and reload your originals.
Caution:
Make sure you do not load the ADF beyond its capacity for your paper size. Also make sure
your originals are not creased or folded, and do not contain holes, staples, tape, or other materials
that could obstruct the feeder.
10. Follow the prompts on the LCD screen to clear any error messages.
Parent topic:
Related references
Paper Jam Problems Inside the Product
Paper Jam Problems in the Main Tray
Paper Ejection Problems
If you have problems with paper ejecting properly, try these solutions:
• If paper does not eject fully, you may have set the wrong paper size. Cancel printing to eject the paper.
Select the correct paper size when you reprint.
• If paper is wrinkled when it ejects, it may be damp or too thin. Load new paper and be sure to select
the correct paper type setting when you reprint.
Parent topic:
Related references
Paper Jam Problems Inside the Product
291
Summary of Contents for WorkForce 545
