E
Load paper with the printable side up, at the center of the rear MP tray. The printable side is often whiter or
brighter than the other side.
F
Slide the edge guide to the edge of the paper, but not too tightly.
Note:
❏
After loading paper, set the paper size for each paper source. Paper is fed from the appropriate paper source
depending on the setting. Use the panel utility to set the paper size.
&
“Paper Size Loaded Setting” on page 74
❏
For plain paper, do not load paper above the line just under the
d
arrow mark inside the edge guide. For Epson
special media, make sure the number of sheets is less than the limit specified for the media.
&
“Selecting which tray to use and its loading capacities” on page 18
❏
Up to 1 sheet of Legal-size paper can be loaded at a time.
Loading Envelopes
Follow these steps to load envelopes:
Note:
The illustrations in this section are from a similar product model. Although they may differ from your actual product, the
method of operation is the same.
WP-4011/4015/4025/4090/4091/4095 User’s Guide
Paper Handling
25