LCD screen message
Condition/solution
Combination of IP
There is a problem with the network connection to your product. Check the
address and subnet
solutions in this guide.
mask is invalid. See
your documentation.
Recovery mode
An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.
Parent topic:
Related references
Where to Get Help
Paper Jam Problems Inside the Product
Paper Jam Problems in the Paper Cassette
Paper Jam Problems in the Auto Duplexer
Related topics
Loading Paper
Placing Originals on the Product
Solving Network Problems
Running a Product Check
Running a product check helps you determine if your product is operating properly.
1.
Disconnect any interface cables connected to your product.
2.
Load plain paper in the product.
3.
Press the
home button, if necessary.
4.
Press the arrow buttons to select
Setup
, then press
OK
.
236