Modello - Modèle - Model
Modell - Modelo
GLEE GLASS 41
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
23/68
N° DOC
UM000500
13. EQUIPMENT IDENTIFICATION
•
Located on the plate affixed to the machine to detect the technical data.
•
Check the model and power supply voltage before carrying out any operation.
• If discrepancies are found, immediately contact the manufacturer or the company that
supplied the equipment.
1. Manufacturer
2. Code
3. Conformity marking
4. Power supply voltage (V)
5. Power supply frequency (Hz)
6. Absorbed electrical power (W)
7. Absorbed electrical power in
defrosting (W)
8. Light max. power (W)
9. Gross volume
10. Type and quantity of refrigerant
11. Climate class
It is strictly forbidden to remove, tamper with the plate and change
or alter the data contained in it.
1
2
3
4
5
6
7
8
9
10
11
11
*Example of data plates
12. ENERGY SAVING TIPS
•
Install the appliance in a dry, well-ventilated room away from heat sources (radiator,
cooking surface and so on) and in a position out of direct sunlight.
•
Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation
to the back of the appliance causes an increase in energy consumption and reduces
cooling efficiency.
•
The internal temperature of the appliance depends on the room temperature, how often
the doors are opened and where the appliance is placed. These factors have to be taken
into account when setting the thermostat. Only open the doors when strictly necessary.
•
Let hot food and drink cool down before placing them in the appliance.
•
The positioning of the shelves in the fridge has no effect on energy efficiency.
• The fridge compartment light system uses a LED light, which at the same time ensures
more efficient lighting and reduced energy consumption.
14. PROLONGED SWITCH OFF
When the unit is not used for a long time, please take note of the following procedures:
•
Unplug the unit.
•
Clean and dry the tank well.
•
Leave the glass door open to avoid possible formation of bad odours
•
Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric
agents.
