Modello - Modèle - Model
Modell - Modelo
MULTIFRESH PLUS MODULAR
MULTIFRESH PLUS MODULAR WL
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
16/60
N° DOC
UM000472
To unpack the bench proceed as follows:
1. Unscrew the screws and remove the wooden cage.
2. Remove the plastic cover.
3. Unscrew the screws from the wooden base.
4.
Using the hydraulic jack.
5. Remove the wooden base.
6.
Position the bench adjusting the feet.
1
2
3
4
5
The appliance, equipped or not with
its packaging, must be carefully stored
inside warehouses or premises protected
from bad weather, atmospheric agents
and direct exposure to sunlight at a
temperature between 0 and +40 °C.
6. CHOICE OF THE INSTALLATION SITE
In selecting the place of installation, ensure that the following instructions are observed, this being vital for proper and troublefree
working of the cabinet:
•
Do not install the cabinet in the vicinity of heating radiators or other heat sources.
•
Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
•
Do not expose the refrigeration unit to air currents from fans, open doors, conditioning units.
•
Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons and other obstacles.
•
It is necessary taht the condensing unit obtains a good circulation of air around it; also the area around the condensing unit should
not be obstructed by boxes or other objects; keep a distance from the wall of
10 cm
. at least.
Air-Condi�on
