Modello - Modèle - Model
Modell - Modelo
EXTRA SLIM COOL EMOTION
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
20/52
N° DOC
UM000300
18. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate
pre-established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
1.
Unlock
the electronic controller by hold down “SET” button for 5 sec. (on the display the word “UNLOCK” will
appear).
1.
Press the (SET)
key
in order to see on display the temperature set point.
2. Press the (
▲
) key or the (
▼
) key
in order to increment or decrement the temperature set point.
3.
Press the (SET) key
in order to store the
new
temperature set point.
LIGHT SWITCH
(Short pressure)
19. MALFUNCTION AND REMEDIES
Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
THE UNIT DOES NOT START
CAUSE
SOLUTION
AUTHORISED STAFF
Check that the unit is properly plugged
Insert the plug
User
Check that the unit is properly plugged
Insert the plug correctly
User
Check that the plug cord is broken
Replace the plug cable
Technical support
If power failure is not due to any of the above causes, call the nearest after-sales service immediately, empty the cabinet and store the foods
in coldrooms or refrigerators that may ensure their preservation temperature.
THE INTERNAL TEMPERATURE IS NOT COLD ENOUGH
CAUSE
SOLUTION
AUTHORISED STAFF
Check door is perfectly closed
Close correctly
User
Make sure that the cabinet has been filled correctly
Load the product correctly
User
Check that the unit is not adjacent to sources of heat
Position the equipment correctly
User
Check that behind the cabinet air can properly circulate.
Position the equipment correctly
Technical support
Check the temperature setting
Set the correct temperature
User
Check that there is not too much ice on the evaporating shelves
Defrost the equipment
User
If failure to cool should is not due to any of the above reasons it it persists on even after the above checks, resort to the nearest after-sales service.
THE UNIT IS NOISY
CAUSE
SOLUTION
AUTHORISED STAFF
Check that all the bolts and nuts are properly fastened
Screw in the screws
User
Check that the unit is placed on an even surface
Position the equipment correctly
User
Check if any pipe or fan is in contact with any other part of the body
Switch off the counter and distance the parts
in contact in the event the problem persists,
contact the support service.
Technical support
Should the inconvenience persist, contact the nearest after-sales service.
