Modello - Modèle - Model
Modell - Modelo
GLEE 42 V2 LITE
GLEE 42 V2 PRIME
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
21/72
N° DOC
UM000325
4.
TRANSPORTATION
The display cabinet is contained in a specially crated package that enables transportation by
the use of fork-lift trucks. For each subsequent handling of the cabinet, the use of the wooden
platform is recommended. Carefully remove the packaging, taking care not to damage the
components and not to throw away those that will be needed for assembly.
The unit is shipped anchored onto a wooden base and protected by corner posts, cardboard top
and nylon wrapping. It must only be handled using a fork lift truck with adequate power to the
load. Positioning the appliance horizontally or on its side or upside down is to be strictly avoided.
Handling is reserved to the authorised after-sales service.
The equipment MUST be kept vertical.
5.
STORAGE AND DISMANTLING
WARNING! Use protective gloves during unpacking and installation
operations.
During unloading and movement operations, avoid tilting the machine and avoid sudden
manoeuvres.
The unit is shipped anchored onto a wooden base and protected by corner posts, cardboard top
and nylon wrapping.
Keep all packaging away from children. For each subsequent handling of
the cabinet, the use of the wooden platform is recommended. Carefully remove the packaging,
taking care not to damage the components and not to throw away those that will be needed
for assembly.
ATTENTION! After unpacking, check that the appliance has not suffered
damage during transportation.
6.
CHOICE OF THE INSTALLATION SITE
In selecting the place of installation, ensure that the following instructions are observed, this
being vital for proper and troublefree working of the cabinet:
•
Do not install the cabinet in the vicinity of heating radiators or other heat sources.
•
Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
•
Do not expose the refrigeration unit to air currents from fans, open doors, conditioning units.
•
Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons
and other obstacles.
•
It is necessary taht the condensing unit obtains a good circulation of air around it; also
the area around the condensing unit should not be obstructed by boxes or other objects;
keep a distance from the wall of
10 cm
. at least.
Air-Condition
