Modello - Modèle - Model
Modell - Modelo
GLEE 43 GLASS
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
15/72
N° DOC
UM000372
ENGLISH
SAFETY ADVICE
WARNING!
Do not damage the refrigerant circuit.
WARNING!
Do not damage the inner or outer walls of the
appliance: the refrigerant fluid circuit may be damaged
.
In case of damage to the walls, do not start the appliance
and contact a qualified service technician.
WARNING!
This appliance must only be installed by
suitably qualified personnel in order to reduce the risks
connected with flammability.
Propane is a natural gas that doesn’t affect the
environment but is inflammable. It is therefore
essential to ensure that all refrigerant pipes are
not damaged before connecting the appliance to
the mains supply. Every 8 gr. Of refrigerant, the
installation room must have a 1 m³ minimum volume. The
amount of refrigerant of the appliance is indicated on the
rating plate of the device. In the event of leakage of the
refrigerant, avoid using open flames or sources of ignition
in the vicinity of the area of the leak. Be careful not to not
damage the refrigerant circuit pipes during positioning,
installation and cleaning.
AVOID USING NAKED FLAMES OR SPARKS INSIDE
THE APPLIANCE.
IN THE EVENT OF DAMAGE:
•
Keep the appliance far from flames or ignition sources.
•
Ventilate the room well for a few minutes.
•
Switch off the equipment, remove the power supply plug
•
Inform customer service.
•
The higher the refrigerant content in the equipment, the larger the
room must be hosting the equipment.
•
In rooms that are too small, a mix of flammable air and gas can form
in the event of a leak.
TRANSLATION OF ORIGINAL INSTRUCTIONS
