-16-
COMMISSIONING
Make sure that the
voltage on the rating plate
corresponds to the mains
voltage.
THE MAINS POWER
LINE THAT THE REFRIGERATED
CABINET WILL BE CONNECTED TO
MUST BE PROTECTED BY A HIGH
SENSITIVITY CIRCUIT BREAKER
(In=16 A, Id=30 mA) AND CONNECTED
TO THE MAINS EARTHING SYSTEM.
Follow the manufacturer’s instructions to
install the unit, using qualified personnel and
complying with the electrical regulations for
the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or
things due to incorrect
observance of this rule.
The earthing is necessary and mandatory for the appliance to work properly.
For the connection, never use reductions, extension cords, adapters or multiple sockets.
The connection must therefore be made DIRECTLY to the mains power supply.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it.
The plug must still be accessible even after installing the unit.
PERIODIC MAINTENANCE
Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
Inspect the power cable to see if it is damaged.
If the power cable is damaged, do not use the appliance and try to repair it: it must be replaced by
the manufacturer or its customer service department or by a similarly qualified person, in order
to prevent any risks.
No protection (grill or guard) should be removed by unqualified personnel and strictly avoid
operating the appliance with these protections removed.
The replacement of lamps must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
