EPTA iarp Gamma 150, Use And Maintenance

-8-

PUTTING   INTO  OPERATION

Check that the voltage on the identification plate is the same as that of the network. 

THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE 

TO BE CONNECTED IS TO BE PROTECTED BY 

A VERY SENSITIVE DIFFERENTIAL SWITCH 

(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO 

THE GENERAL EARTHING PLANT. 

The manufacturer disclaims all responsability for any damage 

to people or

things due to incorrect observance of this rule. 

Earthing is necessary and compulsory by law. 

Absolutely never use reduction units, patch cords, adap-

ters or multiple socket outlets to connect the counter. 

DIRECTLY connect the equipment to the mains.

After plugging, wait till the appliance reaches the right 

temperature before filling it; don’t place the product  over 

the max. load level.

PERIODICAL  MAINTENANCE

Any further adjustments on the refrigerator necessarily require the electric plug to be removed. 

Check periodically the supply cable in order to detect any damage. 

If the power supply cable is damaged, don’t use the equipment and don’t try to repair it: to prevent any 

risk, it must be replaced by the manufacturer, by a member of the after-sales service staff, or anyway 

by a person having similar qualifications. 

In any case, none of the protective elements (the grill, the carter) must be removed by non qualified 

staff. Absolutely avoid using the refrigerator without such protection. 

The replacement of  neon tubes (GAMMA S) must  be carried out only by an Authorized Service 

Center.

MANUAL DEFROSTING AND TANK CLEANING

To always reach the highest efficiency, the refrigerator needs manual defrosting whenever the frost is 

over 5 mm thick. Proceed as follows:

1)  Place the product in special refrigerated containers, 

kept at the same temperature.

2)  Take the plug out.

3)  Put a basin of warm but not boiling waterinto the tank 

and close the glass lids for about 30 minutes.

4)  Rotate the lower draining tubes externally, take the

draining taps off from the inner tank and from the tubes 

and put a basin  under them to collect water.

5)  Carefully wash the tank with water and neutral soap;

rinse and dry well.

6)  Plug in again and wait till the appliance reaches the 

right temperature before filling it again. 

Do not use jet of water to clean the cabinet: electrical wiring could be damaged.

Never use mechanical devices or any other means to accelerate the defrosting process, other than 

those recommended by the manufacturer.