Modello - Modèle - Model
Modell - Modelo
GLOBO 700.3 NG
GLOBO 480.3 NG
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
23/68
N° DOC
UM000406
14. MAINTENANCE
WARNING!
Maintenance must be carried out by technical staff trained and
enabled for intervention on the flammable refrigerants.
WARNING!
Any work carried out on the appliance by the user strictly requires
the power plug being disconnected from the mains socket.
ATTENTION!
Use protective shoes and gloves during maintenance operations.
OPERATION
FREQUENCY
ORDINARY /
EXTRAORDINARY
MAINTENANCE
AUTHORISED
STAFF
Cleaning the outer surface
Based on use
Ordinary
User
Cleaning the accessible inner parts
(do not use tools)
Based on use
Ordinary
User
Checking the power supply, electrical plugs and/or sockets
Six-monthly
Ordinary
User
Seals intactness check
Six-monthly
Ordinary
User
Check the acceptable condition of warning plates
Six-monthly
Ordinary
User
Fridge system tubing intactness check
Six-monthly
Ordinary
Technical support
Inspecting the cables and inner power connections
Six-monthly
Ordinary
Technical support
Replacing the power supply cable
-
Extraordinary
Technical support
Control panel replacement (electronic control unit)
-
Extraordinary
Technical support
Any other maintenance operation not planned in the previous points should
be carried out by the support centres authorised by our dealers or by
qualified staff.
15. TANK CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING
THE POWER PLUG BEFORE CLEANING.
By tank cleaning, proceed as follows:
1.
Place the goods in special refrigerated containers, kept at the same temperature.
2.
Leave the doors open and begin the operation of tank washing when the tank temperature
is the same as the ambient temperature.
3.
Before cleaning the tank the inside temperature must be equal to the ambient temperatur.
4. Proceed with washing and drying the internal chamber with a cloth using neutral PH
detergent and fresh water.
5. Clean the dividers with a cloth, using neutral PH detergent, rinse and dry.
6. Avoid water entering into the appliance lighting units.
7.
Then plug the unit and wait till the appliance reaches the right temperature before filling
it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
WARNING!
Do not use jet of water to clean the cabinet: electrical wiring
could be damaged.
WARNING! Never use mechanical devices or any other means to accelerate
the defrosting process, other than those recommended by the manufacturer.
