061715-JA
www.EPVscreens.com
6
Center Support BarInstallation
1.
Insert the
support joiner
into each end of the center support bar.
support joiner
Center support bar
2.
Insert the
Center Support Bar
into the upper top groove on the back of the frame
(not the one where the fix
plate inserts)
with the bottom end near the approximate center point of the frame androtate it in at an angle so
that both ends of the bar are in alignment with the groove
(see Fig. 17 below for details).
Diagonal models 135” and below use 1 x Center Support Bar
Diagonal models above 135” require 2x Center Support Bars
3.
Slide the top end of the bar into the top center point of the frame to complete the center support bar
installation.
This will provide added stability to your frame and added tension to the material.
Screen material edge
Center Support Bar
(Fig. 17)
Remove
push
Center Support Bar
Fixed plate groove
(Do not insert here)
