QX50/QX200/QX2000; (SW Version 6.0.x)
33
QX50/QX200/QX2000 Manual III: Extension User’s Guide
When clicking on the
Address
in the
Caller ID Based Services
table, the caller ID based services configuration pages for the corresponding extension will
be displayed.
The
Caller ID Based Services for Address
page consists of two frames. In the left frame all caller ID based services are listed. Clicking on the
corresponding caller ID based service, its settings will be displayed in the right frame.
Please Note:
Remember to save changes before moving between the caller ID based services configuration pages.
Below are the instructions to configure each caller ID based service available to the user.
To Configure Caller ID Based Services
1.
Press the
Add
button on the
Caller ID Based Services
page. The
Caller ID Based Services - Add Entry
page, where new addresses can be defined,
will appear in the browser window.
2.
Define an optional
Description
of the address.
3.
Select the call type from the
Call Type
drop down list.
4.
Enter the SIP address, extension or PSTN number (dependant on the chosen call type) in the
Address
text field according to the entering rules.
5.
Select the
Presence State
of an extension.
6.
To add an address to the
Caller ID Based Services
table, click
Save
.
7.
Click on the newly created
Address
in the
Caller ID Based Services
table to open the
Caller ID Based Services for Address
page.
8.
From the left frame, choose a Caller ID Based Services. From the right frame, enable, configure and adjust the corresponding service. Do this for each
service. Remember to
Save
the configurations each time moving between the Caller ID Based Services configuration pages.
To Edit Caller ID Based Services
1.
Select the checkbox of the corresponding address that has to be edited in the
Caller ID Based Services
table. The
Caller ID Based Services - Edit
Entry
page will appear in the browser window.
2.
Change the
Description
of the address, if needed.
3.
Change the
Call Type
and the
Address
defined in the corresponding fields.
4.
Change the
Presence State
of the extension, if needed.
5.
Save
changes.
6.
If the reconfiguration of
Caller ID Based Services
is needed, click on the corresponding
Address
in the
Caller ID Based Services
table to open the
Caller ID Based Services for Address
page.
7.
From the left frame, choose a Caller ID Based Services. From the right frame, change the corresponding service settings, if required.
Remember to
Save
the configurations each time moving between the Caller ID Based Services configuration pages.
Hiding Caller Information
The
Hiding Caller Information
service is used to hide QX IP PBX user information depending on the called destinations. When this service is activated,
Unknown
or
Anonymous
(or similar text, depending on the type of the phone) will be displayed on the called phone when the current user of QX IP PBX
makes outgoing calls to the selected destination.
Attention:
Using the “Block Last Caller” operation from the handset for the caller with the hidden caller ID (for example, anonymous@anonymous or
similar) may block all unknown callers.
The
Enable Service
checkbox selection hides the current extension’s information when calling to the corresponding
Address
listed in the Caller ID Based
Services table.
Please Note:
Even if the
Hiding Caller Information
service is
enabled, it shall work only for internal PBX calls and SIP calls. If you
call through FXO/ISDN port to a PSTN number, the called party will
still see your caller ID. To hide your caller ID for PSTN destinations,
contact your PSTN operator.
Fig.III- 22: Hiding Caller Information page
