Epygi Technologies
Using Quadro Features on IP Phones
7.17
ACT-P104SLD IP Phone
7.17.1
Limitations Specific to ACT-P104SLD IP Phone
The phone cannot be used as a Quadro Remote Extension if it is placed behind a NAT.
See also
7.17.2
Feature Codes on ACT-P104SLD IP Phone
This section presents the feature codes for PBX Services accessible during a call specific to ACT-
P104SLD IP Phone and serves as a supplement to
Quadro Feature Codes on IP Phones
.
PBX Services accessible during a call
Buttons
Call Hold
Hold
Call Waiting
Line button with a flickering LED
Call Blind Transfer
Call Transfer with Consultation
Transfer
Æ
number
Æ
Transfer
Call Conference
Conference
Æ
number
Æ
Conference
7.17.2.1
To Put a Call on Hold
During a call press the Hold key. The LED of the corresponding line button will start blinking,
indicating that the call is on hold.
While a call is on hold, you can make a second call: press the line button of a free line available to
get a dial tone, and dial the number.
To resume a call on hold, press the line button associated with the held call.
If the phone is connected to two calls, one is in progress and the other is on hold, use their line
buttons to switch between the calls.
7.17.2.2
To Accept a Second Incoming Call
During a call press the line button with a flickering LED to put the call in progress on hold and
receive an incoming call.
7.17.2.3
To Blind Transfer a Call
During a call press the Transfer button to put the call in progress on hold and to get a dial tone on
a free line available.
Dial the number the call is to be transferred to. You may press the Transfer button at the end of
your dialled number to immediately transfer the call, or wait until you hear ring tones to ensure that
the called party is alerted, and then press Transfer.
6
The button is in the right upper corner of the keypad.
PAGE 43 29 May 2006