Quadro Manual I: Installation Guide
Appendix: PC DHCP Settings
Appendix: PC DHCP Settings
The QuadroCS has a DHCP server on its LAN interface that provides DHCP IP addresses
to devices connected to the LAN. This appendix describes how to configure Windows PCs
for DHCP. The PC used to access the Quadro must meet the following conditions:
•
TCP/IP network protocol must be installed.
•
DHCP must be activated to request the IP address automatically.
Please Note
: If your PC is already configured for DHCP, then simply power it on. Verify the
LAN LED is lit. If not, check the cable connections.
Follow the instructions below to install TCP/IP and enable DHCP functionality:
TCP/IP and DHCP under Windows 2000/Windows XP
Windows 2000 and Windows XP PCs with Ethernet cards or adapters normally are config-
ured with a TCP/IP network connection by default. Nothing additional needs to be installed.
To enable the DHCP functionality, you may have to modify the properties of TCP/IP:
1. Click
the
Start button. Choose Settings, then
Control Panel.
2. Double-click on the Network Connection icon
to open the corresponding window. Select Lo-
cal Area Connection with the right mouse
button and select Properties.
3. Highlight
Internet Protocol (TCP/IP) and click
Properties. The corresponding window will be
displayed.
QuadroCS (SW Version 3.1.x)
33
Summary of Contents for QuadroCS SW-Version
Page 1: ......