QuadroFXO Manual II: Administrator's Guide
Quadro's Graphical Interface
QuadroFXO; SW Version 5.1.x
23
•
Custom – this selection allows to use a custom SMS gateway. Selection requires following parameters to be inserted:
o
Resource text field requires the HTTP resource name on the SMS gateway, for example: /http/sms.cgi.
o
Parameters text field requires the parameters to be submitted to the resource address. The value of this field represents a string
with tokens (separated by percent (%) symbols) inside. Each token indicates a value of the certain field on this page. The value is
dependent on the SMS gateway requirements. For example:
user=%username%&password=%password%&to=%to%&from=%from%&text=%text%
The tokens are the strings that have the following dependencies from the field in this page:
%username% – indicates the username defined in the field Username
%password% – indicates the password defined in the field Password
%to% - indicates the password defined in the field SMS Recipient Address
%from% - indicates the password defined in the field SMS Sender Address
%text% - indicates the SMS text generated by Quadro (voice mail notification, event notification, etc.)
o
Server text field requires the IP address or the host name of the SMS gateway.
o
Port text field requires the port number of the SMS gateway.
o
Use Secure HTTP checkbox enables access to SMS server via HTTPS. Checkbox selection enables a Secure Port text field that
requires the port number for HTTPS traffic.
o
Request Method manipulation radio buttons allow to select the HTTP request method used by Quadro the access the SMS
gateway: POST or GET.
Send Test SMS is used to send a test SMS to the defined SMS Recipient Address. This button will be enabled if correct values have been
submitted and saved on this page.
Firmware Update
This window allows updating the software of Quadro by installing new firmware (image). Users registered at Epygi will receive a notice when new
firmware is available and will be able to download it from the Epygi Technical Support WEB page.
Updating new firmware requires a working power supply. Quadro is provided with a battery (accumulator). If the battery is low or simply absent the
“There is no battery or voltage is low” warning is displayed.
The
link leads you to the page where the automatic update of the Quadro's firmware (software image) can be
configured.
Please Note:
Installing new firmware will take about 15
minutes. During this time, QuadroFXO, telephony and
Internet access will be disabled.
The firmware update will cause the loss of the following data:
•
All voice mails
Please Note:
If you do not wish to lose your voice data, have
it downloaded from
page prior to
starting the Firmware Update.
•
DHCP leases
•
Transfer
statistics
•
Call statistics
Please Note:
displayed tables to be important, it is recommended to
download them from the corresponding page prior to starting
the Firmware Update.
Fig. II-38: Firmware Update page 1
•
All
pending
events
•
User
specific
GUI
states
The following main processes will be stopped during the firmware update and will be restarted after the installation is completed:
•
Voice
Software
•
Network
Time
Protocol
Daemon
•
Network
Interface
Statistic
Daemon
•
Dynamic
DNS
Daemon
Next will move you to the second page of Firmware Update where the image file should be selected.
Attention:
Pressing the Next button will stop some vital processes on the Quadro, therefore you will need to reboot your device manually even if you
have cancelled the firmware update procedure on the following steps.
