QuadroFXO Manual II: Administrator's Guide
Quadro's Graphical Interface
QuadroFXO; SW Version 5.1.x
43
When the system accepts the settings, the corresponding entry will be logged to the Authorized Phones Database. The detected PSTN caller
address must correspond to the one applied by the caller, the FXO line must be available on the Quadro, there must be network connectivity and the
destination must be reachable. The PSTN caller will then be disconnected from the Quadro's Auto Attendant and the defined Call Back destination
will receive a call from the Quadro within the next 45 seconds. Answering the incoming call, the PSTN caller will be reconnected to the Quadro's
Auto Attendant.
Non-Permanent Call Back configuration service allows the trusted caller to organize one-time Call Back to the defined PSTN destination. In this
situation, no entry will be logged to the Authorized Phones Database.
By calling Quadro's PSTN number (that is previously routed to the Auto Attendant) and entering the Auto Attendant menu, the caller is able to use
the
*5
menu (see Feature Codes) to modify the Call Back destination for the already registered Caller in the Authorized Phones Database.
The system will ask the caller to login by dialing the number and an appropriate password for the Quadro's extension that is used as login extension
in the Call Back settings. After successful login, the PSTN caller should follow the voice instructions for reconfiguring the existing entry in Authorized
Phone database.
The detected PSTN caller address must correspond to the one applied by the caller, the FXO line must be available on the Quadro, there must be
network connectivity and the destination must be reachable. The PSTN caller will then be disconnected from the Quadro's Auto Attendant and the
defined Call Back destination will receive a call from the Quadro within the next 45 seconds. Answering the incoming call, the PSTN caller will be
reconnected to the Quadro's Auto Attendant.
