QuadroFXO Manual II: Administrator's Guide
Quadro's Graphical Interface
QuadroFXO; SW Version 5.1.x
64
VoIP Carrier Wizard
The VoIP Carrier Wizard is used to define access codes for available VoIP Carrier accounts which will particularly allow you to reach users over IP-
PSTN providers or to call to the peers registered on the certain SIP servers by dialing simple digit combinations.
Attention:
The VoIP Carrier Wizard is not available when the QuadroFXO is in the slave mode, i.e. it shares its FXO lines to the Quadro IP PBXs.
For each configured VoIP carrier, the wizard creates a specific IP-PSTN routing rule in the
table. This entry is available to PBX users
only, which means only PBX users can make calls to the corresponding VoIP carrier. Additionally, a virtual extension automatically generated in
will be registered on the defined VoIP Carrier’s SIP server. The settings of that extension will be used to make calls from
Quadro’s users towards the created VoIP Carrier will be placed.
VoIP Carrier Wizard – Page 1 provides a following option of
describing the VoIP carrier:
When predefined carrier is selected in the VoIP Carrier drop
down list, the SIP Server and Port will be already predefined
in the next page. Manual selection allows you to manually
set up the VoIP Carrier settings.
The Description field allows you to insert an optional
description of the VoIP Carrier.
Fig. II-111: VoIP Carrier Wizard page
The prioritized list
1231
1[1-3]3[0-8]
{100-150, asd, \*\?}1
123?
?2?1
[1-3]???
12*31
123*
{11-15}3*
*2*1
*1*
[1-3]*
*
