QuadroFXO Manual II: Administrator's Guide
Quadro's Graphical Interface
QuadroFXO; SW Version 5.1.x
47
In the first case, RTP statistics will be logged if remote extension or IP line user is calling locally to the Quadro’s extension or auto attendant.
The Configure Call Quality Event Notification link leads to the Configure Call Quality Event Notification page where call quality control
notification specifics can be configured.
From the Configure Call Quality Event Notification page you may
configure event notification policy when the call quality is lower than
the allowed level.
This page consists of a Notify checkbox, which enables the call
quality monitoring mechanism for the corresponding event
notifications, and a Call Quality less than drop down list where the
least satisfactory call quality should be selected. When a call with the
quality less than the level selected here is registered on the Quadro,
an event notification will appear. When the Notify checkbox is
disabled, no Call Quality events will occur on the Quadro.
Please Note:
The ways of notification for the Call Quality events
should be configured from the
Fig. II-82: Configure Call Quality Event Notification page
The Configure System Events link leads to the
page where the methods of notification for each system event can be configured.
FAX Statistics
The FAX statistics page is accessed from the Call Statistics page by
clicking on the FAX link in the Details column for the calls that
contain T.38 FAX transmission.
The FAX statistics page provides information about received and
transmitted packets, lost, bad and duplicated packets. This statistics
refers only to the T.38 FAX transmission. The FAX statistics is not
available for the FAX transmitted with other protocols.
Fig. II-83: FAX Statistics page
SIP Settings
The SIP Settings provide information on the SIP receive UDP and TCP ports and allows you to select DNS server configurations for SIP and the SIP
timers scheme.
The UDP Port indicates the SIP UDP (User Datagram Protocol)
receive port number. By default 5060 is selected and used. The
SIP UDP port cannot be in the selected RTP/RTCP port range
for FXS and IP lines (see
), otherwise the “Mapped
port for SIP shouldn’t be in RTP port range” error message
appears.
The TCP Port indicates the SIP TCP (Transmission Control
Protocol) receive port number. By default, 5060 is selected and
used.
Please Note:
Quadro will not use TCP protocol as a transport
for SIP messages if the TCP Port field is left empty.
The TLS Port indicates the SIP TLS (Transport Layer Security)
receive port number. By default, TLS port is not used and is
empty (coded to 0). TLS port number should be different from
the TCP Port number.
The Reaml text field requires messaging level information to be
included in SIP messages sent by Quadro. This information
might be used by remote side for authentication purposes.
Fig. II-84: SIP Settings page
Enable Session Timer enables advanced mechanisms for connection activity checking. This option allows both user agents and proxies to
determine if the SIP session is still active.
The DNS server for SIP radio button group allows you to choose between regular DNS servers configured in the
page and specific
DNS servers for SIP traffic.
•
Use default is used to apply regular DNS servers for SIP traffic.
•
Specific is used to enable SIP specific DNS servers. For this selection, both primary and secondary SIP DNS servers should be defined in the
SIP DNS 1 and SIP DNS 2 text fields. At the least, a primary DNS server should be inserted.
The SIP Timers radio button group is used to define the timeouts of the SIP messages retransmission.
•
RFC 3261 will apply standard SIP timers described in the corresponding specification.
