QuadroFXO Manual II: Administrator's Guide
Extension User’s Menus
QuadroFXO; SW Version 5.1.x
95
When clicking on the Address in the Caller ID Based
Services table, the caller ID based services configuration
pages for the corresponding extension will be displayed.
The Caller ID Based Services for Address page
consists of two frames. In the left frame all caller ID
based services are listed. Clicking on the corresponding
caller ID based service, its settings will be displayed in
the right frame.
Please Note:
Pay attention to save changes before
moving among caller ID based services configuration
pages.
Fig. 3-19 Caller ID Based Services for Address page
Below is the guidance on configuration of each caller ID based service available to the user.
To Configure Caller ID Based Services
1.
Press the Add button on the Caller ID Based Services page. The Caller ID Based Services - Add Entry page where new address can be
defined will appear in the browser window.
2.
Define an optional Description of the address.
3.
Select the call type from the Call Type drop down list.
4.
Enter the SIP address, extension or PSTN number (dependant on the chosen call type) in the Address text field according to the entering rules.
5.
To add an address to the Caller ID Based Services table, click Save.
6.
Click on the newly created Address in the Caller ID Based Services table to open the Caller ID Based Services for Address page.
7.
From the left frame, choose a Caller ID Based Services and enable, configure and adjust corresponding service(s) settings in the right frame.
Pay attention to Save configuration each time moving among Caller ID Based Services configuration pages.
To Edit Caller ID Based Services
1.
Select the checkbox of the corresponding address that has to be edited in the Caller ID Based Services table. The Caller ID Based Services -
Edit Entry page will appear in the browser window.
2.
Change
the
Description of the address, if needed.
3.
Change
the
Call Type and the Address defined in the corresponding fields.
4.
Save changes.
5.
If the reconfiguration of Caller ID Based Services is needed, click on the corresponding Address in the Caller ID Based Services table to
open the Caller ID Based Services for Address page.
6.
From the left frame, choose a Caller ID Based Services and change service(s) settings in the right frame, if required. Pay attention to Save
configuration each time moving among Caller ID Based Services configuration pages.
Incoming Call Blocking
Incoming Call Blocking allows blocking unwanted incoming calls for a Quadro extension. This page provides the necessary settings for incoming
call blocking. It indicates if the service is enabled for the particular caller and whether or not the custom message will be used to inform the caller
about the call being blocked. If the service for the particular caller has been enabled by the administrator and has been stated as protected, it cannot
be disabled by the user.
Please Note:
Since the administrator can protect the service from being disabled by you, contact the administrator if callers complain that they
cannot reach you.
The Enable Service checkbox selection blocks all calls to the current extension from corresponding Address listed in Caller ID Based Services
table Incoming Call Blocking service is configured for.
The Send Message to Caller Party checkbox is available when the service is enabled and initiates a message to inform the caller that their line has
been blocked. Otherwise, the calling party will be disconnected without notification.
The Restore Default Blocking Message File restores the default incoming call blocking message if another user-defined file has been previously
selected. When the checkbox is selected, the file upload possibility will be disabled.
