QuadroM-E1/T1 Manual I: Installation Guide
Configuring the QuadroM-E1/T1
QuadroM-E1/T1; (SW Version 5.2.x)
30
Signaling Type CAS
Fig. I-29: Trunk T1 Signaling Type CAS page
If you selected CAS as your Signaling Type on the Trunk Settings - Edit Entry page, you
will get the page shown above using the Trunk link.
The Incoming Interdigit Service link leads to the page where the dial plan for incoming
E1/T1 calls from CO/PBX to the Quadro can be configured. The Incoming Interdigit Ser-
vice is used to configure E1/T1 dial plan for the incoming calls from CO/PBX to the Quadro.
This service allows you to speed up the call establishment procedure by detecting the prefix.
The calls will be speed up by the timeout defined in the Incoming Digits Timeout text field
(see below). Consult with your CO before making changes in the E1/T1 dial plan.
In the Incoming Digits Timeout text field the time period may be specified, during which in-
coming digits from the destination party calling Quadro will be collected before being applied
as an incoming called number. Values between 0 and 20000 (in milliseconds) are required.
Summary of Contents for QuadroM-E1
Page 1: ......