QuadroM-E1/T1 Manual I: Installation Guide
Configuring the QuadroM-E1/T1
QuadroM-E1/T1; (SW Version 5.2.x)
43
AAA Required selection is used to choose one or more Authentication, Authorization, and
Accounting (AAA) settings:
•
Local Authentication – with this checkbox selected, callers will need to pass au-
thentication through Local AAA table (see below) when dialing the current pattern.
•
RADIUS Authentication and Authorization – checkbox is present when RA-
DIUS client is enabled. With this checkbox selected, when dialing the current pat-
tern, callers will need to pass the authentication through RADIUS server (see
above).
•
RADIUS Accounting - checkbox is present when RADIUS client is enabled. With
this checkbox selected, no authentication will take place, but a caller identifying
CDR (call detail report) will be sent to the RADIUS server. Checkbox selection en-
ables accounting on the RADIUS for the certain call. This selection enables the
Client Code Identification checkbox which is used to activate/deactivate the
code identification on the RADIUS server. When the Client Code Identification
checkbox is selected, caller may optionally dial an identity code at the end of the
corresponding route. To make an identified call, caller should dial
Routing Num-
ber
+
+
Identity Code
. Here, Identity Code is an arbitrary digit combination
used to identify the corresponding routing rule. Identity Code can be used to iden-
tify certain called destinations. This will allow to search the calls by the certain
identity code criteria on the RADIUS server (for example, for further billing calcula-
tion purposes).
If the authentication is configured based on the caller’s address, callers will pass the
authentication automatically; otherwise they will be required to identify themselves by a
username and a password.
The Failover Reason(s) radio buttons indicate whether the system should use the next
matching pattern if call setup with the current routing rule fails and allows choosing the rea-
sons to be considered as a failover.
•
None - indicates that matching patterns should not be used regardless of the
failover reason.
•
Failover Reason(s) - indicates possible failure reasons. Failure reasons vary de-
pending on the call type selected on the previous page. If the call cannot be estab-
lished due to selected Failure Reasons, the call routing table will be parsed for the
next matching pattern and, if found, the call will be routed to the specified destina-
tion.
Cannot Establish Connection - failure reason is available for FXO and
ISDN only and indicates cases when connection cannot be established.
Busy - available for PBX, SIP, SIP Tunnel, and IP-PSTN call types and indi-
cates cases when the dialed destination is busy.
Wrong Number - available for PBX, SIP, SIP Tunnel, and IP-PSTN call
types and indicates cases when the dialed number is wrong.
Network Failure - available for SIP, SIP Tunnel, and IP-PSTN call types and
indicates cases when system overload, network failure or timeout expiration
occurred.
System Failure - available for SIP, SIP Tunnel, and IP-PSTN call types and
indicates cases indicated in Network Failure and Other fail reasons.
Other - available for SIP, SIP Tunnel, and IP-PSTN call types and indicates
cases when authorization, negotiation, not supported or request rejected or
other unknown errors occur.
•
Any stands for all failure reasons mentioned in the Failover Reason(s) group.
Summary of Contents for QuadroM-E1
Page 1: ......
