Manual-I: Installation Guide for QX Gateway
Revision 1.2
19
IP Address Assignment – select the IP Address assignment type for the PPPoE interface:
Obtain an IP Address automatically – with this option QX will get an IP address dynamically.
Use the following IP Address – set the IP address manually.
Ethernet
Obtain an IP Address automatically – with this option selected, QX will use DHCP to get an available IP
address from your local network or ISP.
Use the following IP Address – if selected, manually provide the settings for the WAN interface.
VLAN
VLAN ID – select VLAN ID from the configured VLAN list.
Click Next to continue the configuration of the VLAN IP Configuration settings.
Obtain an IP Address automatically – with this option selected, QX will use DHCP to get an available IP
address from your local network or ISP.
Use the following IP Address – if selected, manually provide the settings for the VLAN interface.
WAN Interface Configuration
If your ISP requires a specific MAC address (e.g. for authentication purposes), it can be entered on this page.
The required MAC address can be entered into the User-defined field. If a specific MAC address is not required,
leave the default selection This device selected.
Figure 18: WAN Interface Configuration section
Use the MTU drop-down list to select the maximum size of packet that can be sent in a packet or frame-based
network such as the Internet. QX supports packet fragmentation.
TIP:
The default MTU size is 1500 Bytes for
Ethernet protocol and 1400 Bytes for PPPoE.
