Manual-I: Installation Guide for QX Gateway
Revision 1.2
25
7 Configuring Extensions
Navigating to the Extensions Management page for the first time after the QX initial start or configuration restore
you will be prompted to choose the extensions length applicable to all QX default extensions.
Figure 22: Choose Extensions Length page
The following options are available:
Leave Current Length – keep the current length of QX extensions unchanged. By default, the extension’s
length is 3 on the QXFXO4, QXE1T1 and is 2 on QXISDN4 and QXFXS24. In front of this selection, the
actual configured length of extensions is displayed.
Change Length – change the length of extensions as follows:
Extension Length – select the length of extensions. It will be applied for all existing extensions on the
QX. The length of the extension can be 2, 3, 4.
Extension Prefix – define the prefix the existing extensions as well as the newly created extensions
should start with. The prefix cannot start with the digits 0 or 9.
Attention:
By saving the settings on the Choose Extensions Length page, all existing extensions will lose the cus-
tom voice messages. The device will be rebooted. The Choose Extensions Length page will not appear
again unless the default configuration settings will not be restored on the QX.
QXFXS24 and QXISDN4 is limited to 200, QXFXO4 and QXE1T1 to 400 extensions in total.
To add a new extension:
1.
Click Add Extension.
Enter the extension number.
Select the extension type. The following types are available: Attendant and User Extension.
2.
Click Save to add the new extension to the Extension Management table.
