Manual-I: Installation Guide for QX Gateway
Revision 1.2
31
4.
Click Connect to connect the device with the master and start sharing the onboard lines(trunks) with
master device. After the slave-master connection successfully established, appropriate routing rules will
be created on the Call Routing Table for both devices (slave and master) to support PSTN line sharing.
Figure 28: PSTN Lines Sharing page on the Slave QXISDN4
After successful registration, go to the Interfaces
FXO, Interfaces
E1T1 Trunk or Interfaces
ISDN Trunk page
on the master to check if the shared lines/trunks are available.
Figure 29: ISDN Trunk Settings page on the QX200