OPERATOR INSTRUCTION MANUAL
SWi5TE_Rev02_A5
SWi5TE
FLANGE SPREADING WEDGE
3
2.
TOOL SAFETY
2.1
GENERAL SAFETY
These instructions cover the safe operation and
maintenance of THE EQUALIZER
SWi5TE
FLANGE
SPREADING WEDGE tool. The use of this tool should be
as part of a broader task-based risk assessment, which
should be carried out by the operation supervisor or other
competent person.
Failure to comply with the safety information contained
within this manual could result in personal injury or
equipment damage. Read all instructions, warnings and
cautions carefully, and follow all safety precautions.
The safety of the operator, any assisting personnel and
the general public is of paramount importance. Always
work in accordance with applicable national, local, site &
company-wide safety procedures.
2.2
PERSONNEL COMPETENCY
Only personnel deemed competent in the use of hydraulic
equipment should use these tools.
2.3
DISCLAIMER
Equalizer cannot be held responsible for injury or damage
resulting from unsafe product use, lack of maintenance
or incorrect product and/or system operation. If in doubt
as to the safety precautions and applications, contact
Equalizer using the contact details at the back of this
manual.
1.
INTRODUCTION
The Equalizer™ SWi5TE has been developed to assist in
the spreading of all flange joint types with a minimum
access gap of 4.0 mm (0.16”). The tool can be used
during pipework construction, commissioning or during
routine maintenance.
The SWi tools have less moving parts and no finger pinch
points. The tools have been developed to increase the
spreading distance on each step while gaining easier
access between any remaining stud-bolts within the
flange joint. The SWi tools are supplied with a swivel
handle and safety lanyard attachment as standard.
It is essential that the user familiarises themselves with
the contents of this manual prior to using the tool.
