3
8
3. Using the probe, remove broken glass debris from the chip.
4. If moisture is present in the break, dry out by using the windshield chip
moisture evaporator.
5. If the rock chip area is not open, consider drilling the chip. At a slow setting start
to drill into the glass but be careful not to drill into the PVB (Poly Vinyl Butyral)
Preparing the Bridge and Injector Assembly -
1. Place the injector tip o-ring on the end of the injector assembly. To do so, use a
small drop of resin to wet the injector assembly tip and then put the o-ring in
place.
Curing Procedure -
1. When the repair is to your satisfaction, release the pressure by loosening the
injector pressure rod.
2. Release the lever on the vacuum cup.
3. Remove the bridge and injector assembly.
4. Wipe away any residual resin.
5. Apply a drop of pit filler resin.
6. Place a mylar square cure sheet onto the pit filler resin. Be sure to gently place the
cure sheet in a downward laying motion and let gravity do the rest.
