Preheating
Select the preheating temperature by turning the thermostat knob clockwise to the desired setting – usually
anywhere between ‘6’ and ‘8’. The red indicator light will turn on. The preheat time will be approximately 10 –
15 minutes. When the preset temperature has been reached, the red indicator light will turn off.
Baking
After the preheat process is complete, you may adjust the temperature by turning the thermostat knob to the
desired setting. The red indicator light will be on when unit is heating, and off after it has reached the preset
temperature.
The
SODIR
crepe machines can be used for a wide variety of foods. Baking times will vary depending food
products, temperature settings and desired results. After depositing batter to the top plate, use the T-shaped
wooden spreader provided with the machine to achieve uniform distribution of batter over the surface. It will
usually take thirty (30) seconds to a minute for the crepe product to bake to a golden brown on both sides. It is
recommended that the crepe be turned over approximately half way through baking.
To turn the crepe machine
‘off’
, turn the knob counter-clockwise until it stops. It will point to the yellow dot at
the 12:00 o’clock position and the red indicator light will go out.
CLEANING
WARNING: Disconnect (unplug) electrical power supply before cleaning
Allow the crepe machine to cool down to a safe temperature before cleaning. Use a cloth dampened with a
soap and water mixture to clean the stainless steel housing and top plate. Clean the machine thoroughly at
the end of each day. Failure to do so may cause hard to remove build up. To remove build up on the top
plate, use an industry standard food service grade degreaser. For tough to remove carbon buildup, use a
commercially available carbon remover.
DO NOT spray the unit with any cleaning liquid before unplugging it.
DO NOT allow water to drip into the housing or around the electrical components.
DO NOT immerse in water for cleaning.
You should inspect all parts on a regular basis to ensure that all is in proper working order. If a part is
damaged, have the unit repaired by an authorized service agency prior to returning the unit to operation. If you
have trouble locating a service agency in your area, please consult our website at
http://www.equipex.com/
, or
call us at 1-800-649-7885 and ask for customer service.
All manuals and user guides at all-guides.com
