24
With the position 3 of the DIP-SWITCH in ON (SA KEY), the multipurpose relay will be activated
whenever the SA switch will be pressed, and with the position 3 of the DIP-SWITCH in OFF the
multipurpose relay won't be activated when the SA switch will be pressed.
MULTIPURPOSE RELAY
MULTIPURPOSE RELAY
ACTIVATION WITH THE
ACTIVATION WITH THE
SA SWITCH
SA SWITCH
DISABLED. ENABLED.
PROGRAM INTERRUPT WITH THE MIC SWITCHES CONFIGURATION
The base station WBS-202 can be configured to make the program input signal will be
interrupted while the channel A and/or B MIC is activated with an internal DIP-SWITCH (DSW1,
positions 4 and 5, PROGRAM INTERRUPT LINE A, PROGRAM INTERRUPT LINE B, placed at the middle
of the main PCB of the unit).
The factory set-up disables both program interruptions. The DIP SWITCH positions 5 and 6 in
OFF.
PROGRAM INTERRUPT
PROGRAM INTERRUPT
WITH THE CHANNEL A WITH
THE CHANNEL A
MIC SWITCH DISABLED.
SWITCH DISABLED.
PROGRAM INTERRUPT
PROGRAM INTERRUPT
WITH THE CHANNEL B WITH
THE CHANNEL B
MIC SWITCH DISABLED.
MIC SWITCH DISABLED.
SA SWITCH MODE CONFIGURATION
The SA (Stage Announce) switch of the base station WBS-202, can be configured so that after
hold it 5 seconds pressed, remain pressed on permanent (latch) or that the switch work always in
the PTT (Push to Talk) mode. In the latch mode, when it is pressed continuously, the base station
emits a slight beep.
The SA switch configuration mode was made by an internal DIP-SWITCH (DSW1, position 6, SA
LATCH MODE, placed at the front left of the base station main board).
The factory default mode disables LATCH work, that is the position of this 6-DIP SWITCH OFF.
SA SWITCH CONFIGURED
SA SWITCH CONFIGURED
IN PTT (Push to Talk) MODE.
IN LATCH MODE.
WB-200 SERIES INTERCOM SYSTEM — WBS-202 DUAL CHANNEL WIRELESS BASE STATION
