LED ALARM CLOCK MANUAL
Model: 30037
TO OPERATE THE CLOCK:
When plugged in an AC outlet, the display will blink on and off meaning the incorrect time is being displayed. You should always
check the time when this is indicated. The clock will automatically displayed AM/PM, but you must be sure to correctly set the
indicator for the time and alarm. When the PM indicator is on, “PM” will be displayed and when the AM indicator is on, nothing will
be displayed. When the alarm indicator is displayed, then the alarm will sound at the set time.
TO SET THE TIME:
Slide the TIME SET switch (2) to T. Set. Press and hold the HOUR button (5) to your desired hour. Be careful to set AM/PM correctly.
When PM time is set, “PM” will appear on display. Press and hold MINUTE SET button (3) to your desired minute. Slide the TIME SET
switch (2) to the lock position.
TO SET THE ALARM TIME:
Slide the ALARM switch (2) to A. Set. Press and hold the HOUR SET button to your desired hour. Be careful to set AM/PM correctly.
When PM time is set, “PM” will appear on display. Press and hold MINUTE SET button (3) to your desired minute. Slide the A. SET
switch (2) to the lock position.
TO TURN THE ASCEDING ALARM ON/OFF:
Slide the ALARM ON/OFF SWITCH (1) to the “ON” position. A bell symbol will be visible on the display when the alarm is activated.
The alarm will sound at the selected alarm time. Slide the ALARM ON/OFF SWITCH (1) to the “OFF” position to turn the alarm off.
TO USE THE SNOOZE FEATURE:
When the alarm is sounding, press the SNOOZE button (4) .The bell symbol will blink on and off indicating the snooze mode is
activated. The alarm will sound again after 8 minutes.
BATTERY BACKUP:
This clock has an optional battery backup feature, designed to retain the time and alarm settings in the event of a power failure. To
use the battery backup, insert one 1 .5V “AA” battery into the Battery Compartment (6) noting the correct polarity. Note that the
battery can be installed without unplugging the clock. If the power fails, the battery backup will automatically continue running the
clock maintaining the time and alarm settings. However, the display will disappear. When the power is restored, the display will
reappear. The battery will maintain timekeeping and the alarm setting for approximately 8 hours during the power failure or
interruption.
If using the battery backup feature, it is recommended to change the battery annually.
