DACCHTS
TS003 Heavy Duty Door Chain
Fitting Instructions
Close the door and align the chain hook opposite the anchor plate.
Mark the position of the 2 screw holes and follow the same
procedure as detailed in D and E. Remember to slide one end of
the door chain into position .
F
Remove screws and position the door anchor over the jack nuts,
re-insert screws and tighten.
Insert jack nuts into the holes and tighten each screw to pull the jack
nuts into position. As the jack nuts are screwed, the 4 legs will bend
behind, tightly forming a metal claw behind the plastic of the door.
NB:
In the event that the jack nut spins, grip the head of the jack nut
with pliers and proceed to tighten. For security, it is essential that all
4 jack nuts are drawn down tightly and fully.
E
D
Drill 4 pilot holes with 2.5mm drill at 30mm deep. You may encounter
steel reinforcement in the door, simply drill though the reinforcement.
Drill the same 4 holes with the 9.5mm at a 30mm depth.
Mark with a pencil the 4 hole positions of the door anchor .
Select position for door chain . The position of the anchor shown
is to avoid the risk of drilling through the lock mechanism.
Door chain must be fitted 70mm apart.
C
B
A
To fit this Door Chain you will require the following tools:
- Pencil
- Tape Measure
- Power drill
- 2.5mm and 9.5mm (3/8”) drill bit
- Pozidriv Screwdriver
Fitting Instructions for PVCu Doors
Chain Anchor
Chain
Hook
Chain
Wood Screws x
6
Screws x 6
for PVCu fitting
Jack nuts x 6
for PVCu fitting
70 mm
120 mm
A
C
B
B
A
C
ERA
, Valiant Way, Wolverhampton, WV9 5GB
Tel: 01922 490 049 Fax: 01922 494 420 Email: info@erahomesecurity.com
www.eraeverywhere.com
