Using the generator
19
NOTICE!
•
Connect the DC clamps of the charging
cable used first to the battery terminals
and subsequently to the generator. Refer
to the polarity markings on the battery.
−
The red clamp is po
−
The black clamp is negative –
The generator is equipped with a 12V DC socket which may be used for charging
automotive-type batteries only. The no-load voltage is 15 - 30V.
To avoid sparks only connect as follows:
•
The 12V DC socket is fitted with a circuit
breaker. If the breaker trips unplug the
DC cable and press the DC Circuit breaker
/ reset switch.
230V AC Sockets
•
The generator is equipped with two AC
sockets.
•
Connect your electrical equipment to the
socket and use it in the normal way.
WARNING!
The rated power of the connected load must not exceed the generator'
s rated output. Refer to the type label of the electrical equipment you
wish to connect.
Summary of Contents for LGY20i
Page 1: ......
Page 27: ...EC Declaration of Conformity 27 EC Declaration of Conformity ...
Page 28: ......