28
5. Plunge the blade into the material slowly and gently, but firmly. Rest the guide
wheel (12) and base plate (10) onto the surface to be cut. Then move the tool
backwards along the line to be cut.
WARNING!
Always move the tool backward and DO NOT move it forward
for cutting channels!
6. Lift the product from the workpiece before switching it off.
7. Clean the channel cut in the wall with chisel (14) if necessary.
After use
1. Switch the product off, wait for complete stop, disconnect it from the power supply
and let it cool down.
2. Check, clean and store the product as described below.
Care & maintenance
WARNING!
Always switch the product off, disconnect the product from
the power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
Clean
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
2. In particular clean the switches and air vents after every use with a cloth and brush.
3. Open the base plate and remove the cutting tools to clean the base plate and the
inside of fixed guards if necessary.
4. Remove stubborn dirt with high pressure air (max. 3 bar).
5. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
1500 W Wall chaser_MNL_EWC1500_DFT_Erbauer_GB_V20518_20180706.indd 28
7/6/18 4:05 PM
Summary of Contents for 3663602795292
Page 35: ......
