Erbauer 3663602796091, Original Instructions Manual

Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment 

(35mm) to the vacuum cleaner adaptor (7) (Fig. E).
1.  Insert the vacuum adaptor (7) into gap between enclosure and base plate and fix 

it in position (step 1).

2.  Insert the suitable vacuum cleaner attachment (Ø35mm) into the vacuum adaptor 

(step 2).

05

Parallel guide (Fig. F)

Attach the parallel guide from the left or right side to perform cuts parallel to the 

workpiece edges. 
1.  Loosen the 2 wing screws (13) by hand (step 1). 
2.  Align the parallel guide (11) with the brackets (12) and insert it through them (step 

2). Use the scale (11a) to adjust the desired width. 

3.  Tighten the 2 wing screws (13) to secure the parallel guide (11) in position.

03

Angle adjustment (Fig. C, D)

WARNING! 

Always ensure the product is switched off and disconnected 

from the power supply before carrying out any work on the product!

The base plate (8) can be angled by 45° to the left or right for bevel cuts. Please 

always adjust the cutting angle according to your needs.
1.  Loosen the quick release lever of base plate (6) (Fig. C step 1).

2.  Slide the base plate (8) forward to disengage from locking position (Fig. C, step 2).

3.  Tilt the base plate (10) to adjust required cutting angle according to scale shown 

(Fig. C step 3 and D).

4.  If the cutting angles are 0 and ±45º, there are 3 locking positions for quick setting. 

Slide the base plate (8) backward to locking position.

5.  Fix base plate (10) by returning the quick release lever of base plate (6) back to 

initial position.

04

Dust extraction (Fig. E)

WARNING! 

Attach a dust extraction device when using this product to 

keep the working area clean! Wear a dust mask when operating this 

product! Dust can be harmful to health! Especially dust and chips of wood 

that has been treated, e.g. with wood preservative or a stain!

18