27
26
USE
01
INTENDED USE
This product is intended for straight cuts in wood and similar material e.g. MDF and
chipboard, with the installed blade. The product must not be used for cutting logs.
02
OPERATION
DEPTH ADJUSTMENT (D1, D2)
WARNING!
Always switch the product off, remove the battery pack
before making any adjustments! Always use the correct blade depth setting!
The correct blade depth setting for all cuts should not be more than a full
tooth of the blade teeth below the material being cut!
Push up the cutting depth adjustment lever (7) and lift the housing to desired depth. Use
the depth scale (18) as a guide.
Push down the cutting depth adjustment lever (7) to secure the cutting height.
NOTE:
The values shown on the depth scale are only valid for cutting 0°
cuts! For bevel cuts the cutting depth will be smaller than indicated.
ANGLE ADJUSTMENT (E1, E2)
WARNING!
Always switch the product off, remove the battery pack
before making any adjustments!
Loosen the cutting angle adjustment knob (13) and tilt the housing to the desired angle. Use
the cutting angle scale (9) as a guide.
Tighten the cutting angle adjustment knob (13) to secure the angle selected.
ON/OFF SWITCH (F)
Press and hold the lock-off button (16) then press the on/off switch (17) to switch the
product on. To switch the product off just release the on/off switch.
NOTE:
The lock off button can be operated from either side to allow left
or right handed use.
LASER (G)
Switch the laser (1) on by slightly pressing the on/off switch (17).
Align the laser beam with the marked cutting line and move the product forward with
even speed.
The laser will automatically turn off a short while after the on/off switch (17) is released.
NOTE:
The laser can be turned on in advance to align the marked lines.
Just press the on/off switch without unlocking the lock-off button.
λ=650nm P
0
≤1mW EN60825-1:2014
LASER
2
WARNING!
Do not stare into the beam, class 2 laser product!
PARALLEL CUTTING (H)
Attach the parallel guide to the product as described above and adjust to the
desired width.
Switch the product on and wait until it runs at full speed before placing it on the
workpiece.
Place the product laterally to the workpiece and use the parallel guide to guide
the product along the workpiece.
NOTE:
Apply light pressure against the parallel guide and move the
product along the edge to achieve an even result.
