Erbauer ERB106SDR, Manual

240W PALM SANDER

VIBRATION

The European Physical Agents (Vibration) Directive has been brought in to help re-
duce hand arm vibration syndrome injuries to power tool users. The directive requires 
power tool manufacturers and suppliers to provide indicative vibration test results to 
enable users to make informed decisions as to the period of time a power tool can be 
used safely on a daily basis and the choice of tool.
Further Advice can be found at www.hse.gov.uk

Vibration total values (triax vector sum) determined according to EN 60745:
Work mode description 1 

Vibration emission value ah =4.86 m/s²
Uncertainty K = 1.5 m/s²

The declared vibration emission value should be used as a minimum level should be 
used with the current guidance on vibration.
Calculating the actual period of the actual period off use can be difficult and the HSE 
website has further information.

The declared vibration emission been measured in accordance with a standardised 
test stated above and may be used to compare one tool with another
The declared vibration emission value may also be used in a preliminary assessment 
of exposure. 

Warning: 

The vibration emission value during actual use of the power tool can 

differ from the declared value depending on the ways in which the tool is used 

dependant on the following examples and other variations on how the tool is used:-
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained 
The use the correct accessory for the tool and ensuring it is sharp and in good condi-
tion.
And the tool is being used as intended by its design and these instructions. 

This tool may cause hand-arm vibration syndrome if its use is not adequately 

managed

Warning:

 identify safety measures to protect the operator that are based on 

an estimation of exposure in the actual conditions of use (taking account of all 

parts of the operating cycle such as the times when the tool is switched off and when 
it is running idle in addition to the trigger time).Note The use of other tools will reduce 
the users’ total working period on this tool.

Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades