Erbauer ERB107SDR, Instruction Manual

1/3 Sheet Sander

position otherwise you will remove material and 

create an uneven surface.

WOrKInG hIntS FOr YOUr 

Sander

1. If your power tool becomes too hot, especially 

when used at low speed, set the speed to 

maximum and run it with no load for 2-3 

minutes to cool the motor. Avoid prolonged 

usage at very low speeds. Always use sand 

paper that is suitable for the material you want 

to sand.

2. Always ensure the work-piece is firmly held or 

clamped to prevent movement.

3. Any movement of the material may affect the 

quality of the sanding finish.

4. Start your sander before sanding and turn 

it off only after you stop sanding. For the best 

results, sand wood in the direction of the grain.

5. Do not start sanding without having the 

sandpaper fitted.

6. Do not allow the sandpaper to wear away it 

will damage the base-plate. The guarantee does 

not cover base-plate wear and tear.

7. Use coarse grit paper to sand rough surfaces, 

medium grit for smooth surfaces and ine grit for 

the final surfaces. If necessary, first make a test 

run on scrap material.

8. Use only good quality sandpaper.

9. The sandpaper controls the sanding efficiency, 

not the amount of force you apply to he 

tool. Excessive force will reduce the sanding 

efficiency and cause motor overload. Replacing 

the sandpaper regularly will maintain optimum 

sanding efficiency.

MaIntenanCe

Remove the plug from the socket before 

carrying out any adjustment, servicing or 

maintenance.

Your power tool requires no additional 

lubrication or maintenance.  

There are no user serviceable parts in your 

power tool. Never use water or chemical 

cleaners to clean your power tool. Wipe clean 

with a dry cloth. Always store your power tool