Erbauer ERB382SDR, Original Instructions Manual

450W 150MM ROTARY SANDER

OPERATING INSTRUCTIONS

NOTE:

 Before using the tool, read the 

instruction book carefully.

Intended Use

The machine is intended for dry sanding of 

wood,plastic, metal and filler material as well as 

painted surfaces.

Machines with electronic control are also suitable 

for polishing.

1. REPLACING THE SAND PAPER/SANDING 

PLATE

Remove the plug from the socket before carrying 

out any adjustment, servicing or maintenance.

1) Selecting The Sand Paper

Depending on the material to be worked and the 

desired material removal, various Sand paper 

qualities are to be used:

-  Use coarse grits to sand down rough finishes 

medium grit to smooth the work and fine grit to 

finish off.

-  The higher the grade number, the finer the grit. 

For rough work, start with a low grade of grit. 

(e.g.60grit) and change to a higher, finer grade 

(e.g.120grit) for finishing.

2) Replacing The Sand Paper

Lift the Sand paper at the side and pull it off the 

sanding plate. Clean the sanding plate, if required. 

Press the new Sand paper against the bottom 

of the sanding plate. To ensure optimum dust 

extraction, the holes of the Sand paper must match 

with those of the sanding plate.

3) Replacing The Sanding Plate (See Fig. 1)

To replace the sanding plate, pull off the Sand 

paper. Loosen and remove the screw.

Replace damaged sanding plates without delay.

Fig. 1

Fig. 4

Fig. 5

Fig. 6

Fig. 3

Fig. 2

9

2

1

8