Erbauer ERI692IPD, Original Instructions Manual

18V BRUSHLESS IMPACT DRIVER 

     ERI692IPD

OPERATING INSTRUCTIONS

NOTE: 

Before using the tool, read the 

instruction book carefully.

INTENDED USE:

This tool is intended for the fastening and 

loosening of bolts, nuts and various threaded 

fasteners. This tool is not intended for use as a 

drill.

BEFORE PUTTING INTO OPERATION

A) CHARGING THE BATTERY

The battery charger supplied is matched to the 

Li-ion battery installed in the machine. Do not use 

another battery charger.

The Li-ion battery is protected against deep 

discharging. When the battery is empty, the 

machine is switched off by means of a protective 

circuit: The tool holder no longer rotates.

In a warm environment or after heavy use, the 

battery pack may become too hot to permit 

charging. Allow time for the battery to cool down 

before recharging.

When the battery pack is charged for the first time 

and after prolonged storage, the battery pack will 

accept a 100% charge after several charge and 

discharge cycles.

B) TO REMOVE THE BATTERY PACK (See Fig. 

A1)

Depress the Battery Pack Release Button (3) firmly 

first and then slide the Battery Pack out from your tool.

C) TO INSTALL THE BATTERY PACK (See Fig. 

A2)

Slide the fully charged Battery Pack onto the tool 

with sufficient force until it clicks into position.  

D) HOW TO CHARGE YOUR BATTERY PACK 

(See Fig. A3)

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet. 

2) Slide the battery pack into the charger, the 

light(a) will be green and flash to indicate the 

charging process has started.

3) When charging is completed, the light(a) will 

Fig. A1

Fig. A2

Fig. A3

Fig. C

Fig. D

Fig. E

Fig. B1

Fig. B2