Erbauer ERI692IPD, Original Instructions Manual

18V BRUSHLESS IMPACT DRIVER 

     ERI692IPD

OPERATION

1. HOW TO USE THE BELT HOOK (See Fig. 

B1&B2)

Screw the Belt Hook on the tool with the screw 

provided in the plastic bag. The Belt Hook can be 

hooked on your belt or pocket, etc.

2. COLLET LOCKING SLEEVE

The collet accepts only standard 1/4” hexagonal 

shank accessories with power groove. Do not use 

this tool as a drill. Tools equipped with shut-off 

clutches are not designed for drilling applications. 

The clutch can shut off automatically and without 

warning. Attempting to restart drilling after shut-off 

has been reached can cause the tool to twist out of 

your hand until the clutch again reaches shut-off. 

Do not attempt to insert quick change type drill bits 

into this chuck.

3.  INSERTING OR REMOVING A BIT HOLDER, 

SOCKET OR SCREWDRIVER BIT (See Fig. C)

Pull the collet locking sleeve forward. Take the 

tool out of the chuck and release the collet locking 

sleeve. 

4.  FORWARD, REVERSE ROTATION AND 

LOCK CONTROL (See Fig. D&E)

Your tool is equipped with a forward, reverse 

rotation and lock control located above the on/off 

switch. It was designed for changing rotation of 

the chuck and for locking the on/off switch in the 

center position to help prevent accidental start and 

accidental battery discharge. 

For forward rotation, (with chuck pointed away 

from you) move the lever to the far left. For 

reverse rotation move the lever to the far right. To 

activate switch lock move the lever to the center off 

position.

CAUTION:

Do not change direction 

of rotation until the tool comes to a 

complete stop. Shifting during rotation of the 

chuck can cause damage to the tool.

5. USING THE LED LIGHT

The LED light allows you to keep a clear view 

under less illuminated circumstances. To turn on 

the light simply press the on/off switch. When you 

release the on/off switch, the light will be off.

Fig. A1

Fig. A2

Fig. A3

Fig. C

Fig. D

Fig. E

Fig. B1

Fig. B2