18V BRUSHLESS DRILL DRIVER
ERI717DDR
Caution is there is leaking liquid from the battery wear protective
clothing, glasses and clothes as this can be acidic.
8. Always disconnect battery charger and remove battery from
charger when the charging is complete.
9. Only use the battery charger specifically stated on the base of
the battery.
FOR BATTERY
1. Always remove the battery pack from the charger immediately
after re-charging is completed.
2. When not in use, remove a charged battery pack from the
charger.
3. Do not charge a damaged battery pack.
4. Do not charge non-rechargeable batteries.
5. Do not install the battery backwards so the polarity is reversed.
6. Do not connect the positive terminal and negative terminal of the
battery to each other with any metal object (such as wire).
7. Do not carry or store battery together with necklaces, hairpins or
other metal objects.
8. Do not pierce the battery with nails, strike the battery with a
hammer, step on the battery or otherwise subject it to strong
impacts or shocks.
9. Do not solder directly onto the battery.
10. Do not expose battery to water or salt water, or allow the battery
to get wet.
11. Do not disassemble or modify the battery. The battery contains
safety and protection devices, which, if damaged, may cause
the battery to generate heat, explode or ignite. The protection
circuit module provided with battery packs is not to be used as a
substitute for a shut-off switch.
12. Do not place the battery in or near fire, on stoves or other high
temperature locations. Do not place the battery in direct sunlight,
or use or store the battery inside cars in hot weather. Heating
the battery can damage the safety circuitry, which can cause
additional heating, rupture or ignition of the battery. Using the
battery in this manner may also result in a loss of performance
Summary of Contents for ERI717DDR
