EG_GenLoc41e_1055_UG_003_UK
Page 20 / 71
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCOGENER reserves the right to make any modifications.
Dct_427_02
5.1.2 Installation of the modem
To install the modem, it is recommended to do the following operations with the modem turned off:
- Remove the SIM card cover on the back side.
- Carefully insert the SIM card into the reader.
- Push the SIM card until hearing a "clic" that ensures its correct positioning.
- Put the SIM cover back.
- Connect the GSM antenna to the connector FAKRA-D.
- Connect the GPS antenna to the connector FAKRA-C.
- For the connection to the DTE, connect the V24 link via the 15-pin Sub HD cable.
- Connect the supply cable to the continuous and regulated power source (for an automobile
application, see the paragraph 5.2).
- Connect the supply cable to the modem and turn on the external power supply.
The modem is now ready.
There are different cases depending on the application installed inside the equipment:
- Without library: corresponds to the Bootloader.
- With EGM standard library
- The application ERCOGENER EaseLoc-Vx.
- The owner application.
We may obtain different display. See the following paragraph.
Way of insertion
of the SIM card