CARDIO LINE 400/400 MED
Technical and optical modifications as well as misprints reserved -
© 2011
by ERGO-FIT GmbH & Co. KG
CARDIO LINE 400/400 MED
Technical and optical modifications as well as misprints reserved -
© 2011
by ERGO-FIT GmbH & Co. KG
2 1
display works. If this is not the case, make sure you followed the steps above
correctly. In addition, verify if there is electricity in the mains socket.
5.4.1
Power supply
Use your exercise machine only on earthed (grounded) mains sockets with 230 V~/50-
60 Hz (see chapter A). If you have any doubts about the power supply at the setup
location, ask your electricity supplier. Only use customary 10 ampere automatic circuit
breakers (type B tripping characteristic). In the rare event that these automatic circuit
breakers should switch off when you switch on your machine, the circuit needs to be
fused with 10 A lead fuses or with a different type of tripping characteristic. In case of
doubt, ask your electrician.
Before connecting your ERGO-FIT exercise machine to your power supply system,
compare the data on the type label (next to power input module) on the allowable
voltage and grid frequency with your local data.
Always connect your machine directly to the mains socket. Never use extender cables
or multi-outlet power strips.
5.4.2
Cabling
If you have connected more than one ERGO-FIT machine to one main switch, please
switch each machine on and off individually.
⊗
Install the cable in such a way that no one can step on it or trip over it.
⊗
Do not place any objects on the cable as it might become damaged.
5.5
Potential compensation
To avoid disturbances, a potential compensation cable may be attached to the
machine. This potential equalisation is not standard equipment. If required, ask the
service to install this feature. In this case, communicate with the service department
or the field staff. As some machines are already prepared for the potential compensation
feature, on-site installation is possible.
5.5.1
Position of the potential compensation clamp
The potential equalisation clamp is located underneath the front wheel cover.
Never connect the potential compensation line to the water or gas supply line or any
other kind of pipe. Always use the appropriate potential compensation connection
only.
