display shows an "E" on the position of the pulse indication (incorrect or no pulse
transmission). In this case, please check again the correct fit of the chest band.
The sender (the electrodes in particular) should be cleaned and dried after use with
warm water and a mild soap for hygienic reasons. Never brush the electrodes! Do not
use alcohol for cleaning!
7.4.2
Operating range of the POLAR sender
The operating range of the sender is approx. 80cm. If you have more than one
ERGOFIT exercise machine, make sure to keep a distance of at least 100 cm between
them to avoid interference of the senders.
7.4.3
Battery of the POLAR sender
If the heart rate transmission only works within a short distance between the sender
and the receiver or not at all after a prolonged operation, it is possible that the sender's
battery is depleted (the battery usually lasts for approx. 2500 hours). In this case,
please send the sender and the depleted battery to the following address:
POLAR Electro GmbH Deutschland
Am Seegraben 1
D-64572 Büttelborn/Klein-Gerau
Your sender will be returned to you with a new battery at a charge. Do not try to
change the battery yourself!
7.4.5
Potential interference
⊗
Screens, electric motors
⊗
High voltage lines (including tramway contact wires)
⊗
Fluorescent tubes in close proximity
⊗
Central heating radiators
⊗
Other electric devices (e.g. mobile phone)
The problem can usually be addressed by moving the machine a few metres away
from the source of interference. In some cases, it is sufficient to change the position
of the machine by a few degrees.
If the heart rate is displayed irregularly despite faultless technical conditions, check
your heart rate manually. In case of doubt, you should see your doctor.
Operation
Technical and optical modifications as well as misprints reserved -
© 2011
by ERGO-FIT GmbH & Co. KG
4 4