Technical and visual modifications as well as misprints reserved -
© 2018
by ERGO-FIT GmbH & Co. KG
Maintenance
3.
You can also tension the belt until the drive shaft stops spinning freely when the belt
is blocked (see section „Checking the Running Belt Tension”).
Tensioning the Drive Belt
The poly-v-drive belt is equipped with a belt tensioner and should not require any manual
tensioning. However, if the drive belt needs more tension, make sure to unplug the machine
plug first.
You may check the belt‘s tension as instructed in „Checking the Running Belt Tension“ by
blocking the running belt. When doing so, make sure the motor is not idling but has full
contact with the belt!
The drive belt is equipped with an adjustment device in case it needs to be tensioned.
Oiling
The oil film underneath the running belt needs to be checked at the latest when the oil can
symbol appears on the display or if you hear grinding noises. In this case perform oiling and
reset the oil interval distance.
The intervals differ depending on the use:
⊗
physiotherapy / low utilization, ca. 500 km
⊗
training facility / average utilization, ca. 1000 km
⊗
training facility / high utilization, ca. 1500 km
Use the provided special oil and a 10ml-syringe. Only use the provided special oil (special oil
is available on demand at ERGO-FIT)! Other oils or lubricants may damage the running belt
and bearing surface and the treadmill might get damaged. Two syringes of 10 ml special oil
are needed for every maintenance procedure.
9 0
Adjusting and tensioning running belt
Retensioning the running belt
Running belt / drive shaft